PBR support for older 5400 switch

[Libras]

Hi

When i configure Policy Based Routing in older 5400 switches i get the following error. All these will have V1 modules only So does this mean HP only support PBR in latest V2 5400 switches ??

Switch-2(policy-pbr-class)# action ip next-hop 192.168.122.10
This command is not supported with v1-modules.  Please enter the command
'no allow-v1-modules' to enable the v2-module capabilities.

[Michael_Breuer]

That's true. You need v2 modules.

Cheers,

Michael

[Richard Litchfield]

Check the modules with (version listed in far right column)

show modules

You also need to disable compatability mode

no allow-v1-modules

Note:

• In Compatibility Mode, no v2 zl features are allowed whether the modules are all v2 zl or not.

• If Compatibility Mode is disabled, and then enabled, the startup config is erased and the chassis will reboot.