HPE Community
HPE Aruba Networking & ProVision-based
1833187 Members
2830 Online
110051 Solutions
New Discussion

Re: Vlan routing 2910s and 1810s into a 2920 stack

 
Galations220
Occasional Contributor

‎02-13-2015 07:35 AM - last edited on ‎02-15-2015 09:02 PM by

‎02-13-2015 07:35 AM - last edited on ‎02-15-2015 09:02 PM by

Re: Vlan routing 2910s and 1810s into a 2920 stack

I know what you are saying, and these machines are not in our domain, however I have never seen that cause this kind of delay.  I RDP from my home computer and it authenticates me in less than a second.

 

 

Remoting to the vlan 1 computers is also fast, but the extra hop to another vlan slows it down significantly.

 

 

Can vlan routing work with layer 3 routing, or do i need to explicitly turn off ip routing for the vlan routing to work?

 

 

P.S. This thread has been moved from Switches, Hubs, Modems (Legacy ITRC forum) to ProCurve / ProVision-Based. - Hp Forum Moderator

0 Kudos
1 REPLY 1
Vince-Whirlwind
Honored Contributor

‎02-15-2015 04:32 PM

‎02-15-2015 04:32 PM

Re: Vlan routing 2910s and 1810s into a 2920 stack

If you can ping it, it's fine. There's nothing at Layer3 that's going to give you a 30second delay on one application.

0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.