HPE Community
HPE Aruba Networking & ProVision-based
1833862 Members
2405 Online
110063 Solutions
New Discussion

Reconfiguring VLANS on a 5412vl

 
KTD22
Occasional Contributor

‎05-13-2014 08:13 AM - last edited on ‎05-13-2014 10:04 PM by

‎05-13-2014 08:13 AM - last edited on ‎05-13-2014 10:04 PM by

Reconfiguring VLANS on a 5412vl

Can you reconfigure the VLANS on a 5412 vl to make it easier to run cable from the switch to the patch panel without criss crossing the cables?

 

 

P.S. This thread has been moved from Switches, Hubs, Modems (Legacy ITRC forum) to ProCurve / ProVision-Based. - Hp Forum Moderator

0 Kudos
1 REPLY 1
Chrisd131313
Trusted Contributor

‎05-19-2014 06:25 AM

‎05-19-2014 06:25 AM

Re: Reconfiguring VLANS on a 5412vl

Hi KTD22,

 

If I understand you correctly you are talking about mdix mode.

 

This is set on a per-port basis, it can be statically set with the following command...

 

interface <interface_number> mdix-mode

 

HTH

-----------------------------------------------------

Don't forget to mark a post resolved if your question was answered.
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.