HPE Community
HPE Aruba Networking & ProVision-based
1830165 Members
2524 Online
109999 Solutions
New Discussion

SNMPv3 user and password setup during auto configuration by dhcp option 66

 
switchie
New Member

‎09-18-2014 05:36 AM - last edited on ‎09-21-2014 06:23 PM by

‎09-18-2014 05:36 AM - last edited on ‎09-21-2014 06:23 PM by

SNMPv3 user and password setup during auto configuration by dhcp option 66

ProCurve J9086A Switch 2610-24/12PWR

 

At the moment our switch is auto configured by a config file what is uploaded during the dhcp request. This functionallity is working fine.

 

Now we like to configure the snmpv3 options.

 

snmpv3 enable

snmpv3 user test auth md5 "abcdefghijklm" priv des "abcdefghijklm"

 

The switch can't  handle the  'snmpv3 user test auth md5 "abcdefghijklm" priv des "abcdefghijklm" '.

 

After auto-configuration the passwords are not set.

 

Is it possible to setup the snmpv3 user passwords during dhcp? Is the config line correct?

 

P.S. This thread has been moved from  Switches, Hubs, Modems (Legacy ITRC forum) to ProCurve / ProVision-Based. -HP Forum Moderator

0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.