Strange character on the console mode

[toto174]

Hi,

I've got two switches 2920-48g , i've tried to do stacking with specific modules and cables.

Build version:   WB.15.05

I've got some strange characters on the console when i've tried to display some commands.

H5.15.000 Companyftware.  Valid l
 use oSoftwareer Softwd to the under vRD DEVELOPMENT COMPANY,         dates
  * New pnnouncemnow at: orking/rss any k













GE-SW-R[24;16H [1;24r

GE-SW-R?25h    ������������������������������������������������om(swbuitime:      10:56:18
   Build version:   WB.15.05
   Bu Monitor ROM Console
1.rofile (primary): ary Softge...
Update scope = ALL devices
Normal update mode. Only those devices requil

 Do you know how i could fix this ?

the 'show console' commabd display this :

GE-SW-RDC-001# K
nk             ;24r [24;22H[24;24H

  Active t Enable
 [All] : All    ate [speec) [0] : 0   


 Console/Serial Link

  Active Console : No 
  Web Agent Enabled [Yes] : Yes

  Terminal Type [VT100] : VT100   
  Screen Refresh Interval (sec) [3] : 3 
  Displayed Events [All] : All     
GE-SW-RDC-001# 

Thank you in advance for your help.

P.S. This thread has been moved from Switches, Hubs, Modems (Legacy ITRC forum) to ProCurve / ProVision-Based. - Hp Forum Moderator

[Richard Brodie_1]

Some of those characters e.g. [1;24r are part of ANSI escapes, so the  answer to that might be 'get yourself a decent terminal emulator' .  Or alternative change your terminal setting to something dumber than a vt100 (not sure what the command dor that is offhand).

However, it looks like your losing characters, so you might have a speed/flow control problem. I would check that you've got all the correct comms setttings, and maybe try a slower line rate, see if that increases your reliability. It might be that you are getting mangled escapes, and it would all come out fine at a lower speed.