CA zoning using MPX 200 router

[Gene Kenny]

Hello

What would be considered the correct zoning for CA when the EVA is a P6500 using the MPX200 router.  Would I zone FP1 of both controllers to Port 1 of the MPX 200, and FP2 of both controllers to Port 2 of the MPX 200? Or do the MPX 200 act as an ISL and they are not zoned?  Any recommendations on how the FCIP route should be configured.

Thanks

[giladzzz]

Hi

as far as I know MPX200 is considered as ISL and is not  zoned look at the quick installation guide

for acceptable configurations

http://h10032.www1.hp.com/ctg/Manual/c02502469.pdf

Regards

[Johan Guldmyr]

HP's SAN Design Reference Guide should also be able to give you more details about this.

When you zone you generally only zone the end-devices.

For anybody to give you recommendations about your FCIP route you need to provide some details about it (speed, latency, etc).