HPE Community
HPE EVA Storage
1837520 Members
3619 Online
110117 Solutions
New Discussion

Command View and raid 0+1

 
SOLVED
Go to solution
Andreag_77
Frequent Advisor

‎07-11-2008 01:36 AM

‎07-11-2008 01:36 AM

Command View and raid 0+1

Hy guys,
someone can tell me if is possible make a RAID0+1 through command view for EVA4000?

thanks
Andrea
0 Kudos
Reply
2 REPLIES 2
Torsten.
Acclaimed Contributor

‎07-11-2008 02:52 AM

‎07-11-2008 02:52 AM

Re: Command View and raid 0+1

It is possible and it is called vraid1 for EVA's.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
IBaltay
Honored Contributor

‎07-12-2008 09:14 AM

‎07-12-2008 09:14 AM

Solution

Re: Command View and raid 0+1

Hi,
EVA uses virtual RAID concept, which is distributed across all disk spindles.
Thus EVA RAID5 is actualy RAID50 and RAID1 is RAID10. The internals are quite good described here:
http://forums11.itrc.hp.com/service/forums/questionanswer.do?admit=109447626+1215882801219+28353475&threadId=886230
the pain is one part of the reality
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.