Configuring boot LUNs on SAN

[Creating boot LUNs on S]

Hi,

I have a two node cluster to be setup.
These two nodes are connected to a EVA4000 SAN via a FC switch
I have to configure two boot LUNs for each of the cluster nodes. How do I configure boot LUNs and install HPUX over them.

I have the following task to do:-
1. Create two boot LUNs for each node in the cluster.
2. Make SAN LUNs visible to the two cluster nodes.
3. Install HP-UX on boot LUN.
4. How do I configure recovery for boot LUNs, do I need to implement IgniteUX or golden image.

Regards,
Naveen

[Luk Vandenbussche]

Hi,

Check the connectivity guide for HPUX

http://h20000.www2.hp.com/bc/docs/support/SupportManual/c00565157/c00565157.pdf