Connect my existing brocade SAN switch with C7000 Enclosure

[Khalid Shakoor]

HI Guruz,

I need to connect my existing brocade SAN switch with C7000 Enclosure having Brocade SAN switch.
I have idea that I need to play with DOMAIN ID, but how no idea, Its very helpful for me if someone share with me the procedure.

Thanks in advance
Khalid

[P Muralidhar Kini]

Hi Kahlid,

>> Its very helpful for me if someone share with me the procedure.
Refer the following link -
http://h20000.www2.hp.com/bizsupport/TechSupport/Document.jsp?lang=en&cc=us&taskId=115&prodSeriesId=3185340&prodTypeId=12169&objectID=c00789468
-> Brocade 4Gb SAN Switch for HP c-Class BladeSystem - Setup, Configuration
and Installation Procedures

This should help you out with the configuraion of the Brocade SAN switch
with C7000 Enclosure.

Hope this helps.

Regards,
Murali

[Johan Guldmyr]

Hi, good link there above how to configure the c7000 san switches.
You need to do some port mapping etc in the on board admin.

Besides that, the DID might be changed automagically when you add new switches to the fabric. If not, google told me this:

To configure the switch domain ID from a command prompt.

1. disable switch
2. configure
1. yes to fabric
2. input domain ID required
3. don't change anything else ( Unless you know what it does)
3. switch enable

Make sure they are at the same (or a supported) fabric os firmware level.

Check out zone merging as well.

[Khalid Shakoor]

Thanks,
Done Successfully

Khalid

[Johan Guldmyr]

Score!

Thanks for updating us Khalid.