HPE Community
HPE EVA Storage
1831043 Members
2458 Online
110019 Solutions
New Discussion

hp ux server unable to identify vg disks from san array

 
70amxster
Occasional Contributor

‎06-04-2018 10:10 AM

‎06-04-2018 10:10 AM

hp ux server unable to identify vg disks from san array

This system has been up and running till we had a power outage, after the power outage we had a linux server not come back because of an fsck required rel5.  Upon further investigation we have three other servers hpux that booted but could not see the vg groups off the san array.  I have ran ioscan -fnCdisk, it picks up the two local drives but nothing off the san array.  The san switch seems to be fine and right now I am at a loss. any help would be greatly appreciated. Dont know much on the san arrays, but it appears that the array for some reason is not extending the virtual disks out to the network?

0 Kudos
Reply
1 REPLY 1
PSPrakash
HPE Pro

‎06-19-2018 08:47 PM

‎06-19-2018 08:47 PM

Re: hp ux server unable to identify vg disks from san array

Hello

You may involve an SAN/Storage expert to see those LUNs are assinged to the Host properly.
Also enure switch can see the HBA Port and Zone configurations too.



I work at HPE
HPE Support Center offers support for your HPE services and products when and how you need it. Get started with HPE Support Center today.
[Any personal opinions expressed are mine, and not official statements on behalf of Hewlett Packard Enterprise]
Accept or Kudo
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.