LTT not seeing NSR

[Jack Trachtman]

I dusted off our old Gen I SAN Appliance, loaded Windows XP Pro on it, connected it to our HP SAN, and then loaded the latest LTT.

On doing a SAN scan, LTT finds our HP libraries and drives, but does not see the m2402 NSR.

I would like to use LTT to upgrade the NSR FW.

Any suggestions on getting LTT to recognize the NSR?

TIA

[Mark Poeschl_2 · Accepted solution]

It looks like the M2402 is not supported by LTT. See the specs at:

http://h18006.www1.hp.com/products/quickspecs/11591_na/11591_na.pdf

I also don't see M2402 firmware at:

ftp://ftp.hp.com/pub2/information_storage/software/ltt/firmware/

where I find everything else.

[Jack Trachtman]

Mark,

Thanks for checking the obvious (which I should have done, even though our FE thought it should work!)

The QS does list the 1200 series, which I think is the same device in a different form factor. I'll check w/HP.