HPE Community
HPE EVA Storage
1754976 Members
3146 Online
108828 Solutions
New Discussion

MSA2312i after a controller replacement an enclosure is showing all disks as unknown

 
andibigb
Occasional Contributor

‎03-14-2014 12:42 PM

‎03-14-2014 12:42 PM

MSA2312i after a controller replacement an enclosure is showing all disks as unknown

Hi everyone, i have just done a hotswap controller replacement to controller A and i have 3 enclosures 1, 2 and 4.

Enclosures 1 and 2 seem fine but according to the Controller A's management GUI it shows that enclosure 4 all the disks are unknown even though controller B's management GUI shows as they are all ok..

Does anyone know how i can resovle this as once it is showing as all ok i would like to upgrade the controller B's firmware to the same as the new controller A (M114R01)

 

Current firmware status 

Controller A - M112R14 (Baselevel) i believe its actually M114R01

Controller B - M111R06

0 Kudos
Reply
1 REPLY 1
Torsten.
Acclaimed Contributor

‎03-14-2014 01:07 PM

‎03-14-2014 01:07 PM

Re: MSA2312i after a controller replacement an enclosure is showing all disks as unknown

Consider to bring both controllers to M114P01 (P, not R), maybe one of the old versions has a problem?

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.