HPE Community
HPE EVA Storage
1824219 Members
3896 Online
109669 Solutions
New Discussion

"Failover Only" or "Failover/Failback"

 
manamirhastam
Frequent Advisor

‎02-27-2007 08:41 PM

‎02-27-2007 08:41 PM

"Failover Only" or "Failover/Failback"

I'm using EVA4000 and two rx2620 servers (HP-UX V2).
I have two HSV200 controllers and also Dual channel FC cards on each rx2620.
I'v installed secure path v3 and I'v defined the preferred paths.
In command view there are some options for Preferred path/mode .
Failover Only and also Failover/Failback.
So wich one is suitable for the mentioned environment ?
As I read HP-UX only supports "Failover only" mode.


0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.