Storageworks San Switch 2/8 default password required....

[Jez Rice]

I have a live novell 6 cluster on an msa1000 based switch fabric with various other servers/library. I urgently need to add an extra node to run as a three node cluster before a faulty node is removed.
It looks as though zoning has been implmented on the switches as well as acl on the controllers.
Using the web based switch interface I can tell that the new hba is visible on the fabric but no zone is being applied by default.
I do not know the telnet login for the switches and so cannot check the zoning setup.
Can anyone please confirm the default UN & PW and a possible way to reset these to default if changed.
Thx

[Luk Vandenbussche]

Jez,

Default UID : admiin
Default PW : password

[Luk Vandenbussche]

Jez,

Default UID : admin
Default PW : password

[Jez Rice]

Thanks for the confirmation but it hasn't worked.
Unfortunatley there is no documentation for this SAN setup so I cannot tell what they may have been changed to..
Is there a way to reset the UN & PW to default?

[Frantisek Kysela]

Hi Jez,
You can try using accounts "factory" or "root". Default password is "password". You can change the admin password with the "passwddefault" command.

Frantisek

[Frantisek Kysela · Accepted solution]

Hi again,
if previous was not working, You can try password "fibranne" for user root.
If nor it not work you must contact Brocade to get the Password Recovery Procedure. It is a special firmware especialy made for your switch You need know a switch WWN for this procedure.

Frantisek

[Jez Rice]

Thx a million.
The correct password was fibranne