The device, \Device\Harddisk0\DR0, is not ready for access yet.

[Attila Aradi_2]

Dear Sirs,
I have the following configuration:
Emulex TP7000 HBA
HSG80
RA 8000
Compaq Proliant 6400R
MS-Windows 2000 Standard Server

for a week the following event appearing in the eventlog:
"The device, \Device\Harddisk0\DR0, is not ready for access yet. "

This message repeating many times in log.
If the server is rebooted then working well for 1-2 days. Then repeating the situation.

Do you have any idea?

Thanks
Attila

[Attila Aradi_2]

Dear Sirs,

in the terminal the following seen:


%EVL--HSG80_1>--31-AUG-2004 14:29:17-- Instance Code: 0258000A
Template: 81.(51)
Occurred on 31-AUG-2004 at 14:29:02
Power On Time: 2. Years, 144. Days, 15. Hours, 43. Minutes, 6. Seconds
Controller Model: HSG80
Serial Number: ZG20100029 Hardware Version: E16(2E)
Software Version: V86G-6(BA)
Informational Report
Unit Number: 4.(0004)
Unit Software Version: 1.(01) Unit Hardware Version: 54.(36)
Retry Level: 1. Retries: 1.
Port: 1. Target: 3. LUN: 0.
SCSI Device Type: 0.(00)
Device ID: "BD01864552" Device Serial Number: "22329C8X"
Device Software Revision Level: "3B05"
SCSI Command Opcode: 40.(28)
Sense Data Qualifiers: 64.(40)
SCSI Sense Data:
Error Code: 112.(70) {current command execution}
Information field is valid
Segment: 0.(00)
Sense Key: 11.(0B) ABORTED COMMAND
ILI: 0 EOM: 0 FM: 0
Information: F7324D01
Additional Sense Length: 10.(0A)
Command-Specific Information: 00000000
ASC: 0.(00) ASCQ: 6.(06)
FRU: 0.(00) Sense-Key Specific: 000000
Instance Code: 0258000A
HSG80_


Do you have any idea?
Thanks.
Attila

[Yaw Eng, Law]

Attila, most probably you have "degrading" harddisks on your RaidArray.

Looking at the "serial console log" event, Port: 1. Target: 3. LUN: 0, Unit Number: 4.(0004); it's shown that the message "The device, \Device\Harddisk0\DR0, is not ready for access yet. " is logged in the server that uses unit D4. The degrading disk is Disk10300 (using port,target,LUN naming convention)

After replacement of the disk, you should see that the event should not be repeating again.