HPE Community
HPE EVA Storage
1845821 Members
4027 Online
110250 Solutions
New Discussion

To differentiate HBA in W2K3 server

 
Nava Murali
Occasional Advisor

‎08-10-2006 08:15 PM

‎08-10-2006 08:15 PM

To differentiate HBA in W2K3 server

Hi all,

1 out of 2 KGPSA HBA card in the server is degraded. This can be seen from data loss in event viewer (system) under CPQKGPSA soure; where it says "The device, \Device\Scsi\CPQKGPSA2, is not ready for access yet."
From my W2K3 server, is there any way identifying to which HBA this event is indicating?

Thanks in advance.
0 Kudos
Reply
2 REPLIES 2
Ivan Ferreira
Honored Contributor

‎08-11-2006 04:12 AM

‎08-11-2006 04:12 AM

Re: To differentiate HBA in W2K3 server

If this is a proliant server, you should have the insight agents installed. Use "HP System Management Homepage" to view the status of the system.

Also, all HBA have a LED. Check the LED status of the adapter.
Por que hacerlo dificil si es posible hacerlo facil? - Why do it the hard way, when you can do it the easy way?
0 Kudos
Reply
Nava Murali
Occasional Advisor

‎08-13-2006 02:20 PM

‎08-13-2006 02:20 PM

Re: To differentiate HBA in W2K3 server

Hi Ivan,
Thanks for your reply. But this does not help much as the HBA is not tottaly down, its degraded where we have this problem intermeternly.
As for the HP MGMT page and LED, all indicate that the HBA working fine.
I am looking for the faulty HBA so we could get it replaced before it actually 'dies'.

Thanks.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.