unable to boot vpar after SAN switch upgrade

[RAKESH_12]

All,

We have recently upgraded our brocade switch firmware. Since he one Vpar has failed to boot successfully over the SAN using 2Gbit FC card - error : :Failed to open (0/8/0/0.1.23.0.0.1.0;)/stand/vmunix.

All other vpars run fine and are using 1Gbit FC cards.

Any ideas on why / how to boot my final Vpar ????

Thanks in advance.
R

[Mike Naime]

How about some more information here...

What did you upgrade from? too?

What are your 2GIG cards? (Manufacturer?)
What Hardware/OS are you running? Versions?
What is your storage device(s)?
What is your SAN configuration?
Are you zoning?
...Etc.

You did not give us a whole lot to go on in your first post.

I have had boot failures without upgrading my SAN switches. The storage controller needed a kick in the port! :-)

Mike