Change c7000 oa Ip address and name

[MeFromil]

hi 

i would like to change the oa ip address and name of c7000 

any best practice for it ? 

[ChrisLynch]

If you added your enclosure with a Fully Qualified Domain Name (FQDN) instead of its IP Address, then go modify the IPv4 Address and OA name in the OA UI or CLI.  Then, go back to OneView, perform a refresh of the Enclosure.  You may be prompted for the hostname and credentials again.  Once that refresh finishes successfully, then that is it.

[MeFromil]

i didnt config it with FQDN 

[skins4ev4]

If I recall, the process is to change the secondary OA IP first, roll over to it and then the primary.  I didn't do this and had to open a case to get the OneView appliance to update the referenced IPs from the engineering console.

[rohw]

The only problem we ran into was DNS.  After changing the IP address for both OAs OneView would not refresh the enclosure.  After the DNS records were fixed, it refreshed with no issues.