HPE OneView
cancel
Showing results for 
Search instead for 
Did you mean: 

OneView 4.1 not reporting correct Virtual Connect Firmware

 
Highlighted
Occasional Contributor

OneView 4.1 not reporting correct Virtual Connect Firmware

I am having a problem where OneView is not reporting the correct firmware revisions.

I can correct the problem by Removing the enclosure and re-adding it but I would like to see if there is a way to have OneView update the FW versions correctly without having to delete and add.

This is not a huge issue; it just makes the FW reporting difficult.

Does anyone have any ideas what I should try? 

Currently installed:

Onboard Administrator 4.80
Onboard Administrator 4.80
HP VC Flex-10 Enet Module 
4.62
HP VC Flex-10 Enet Module 
4.62
HP VC 8Gb 24-Port FC Module 
3.09
HP VC 8Gb 24-Port FC Module 
3.09

Reported within OneView: (after performing a "Refresh")

Onboard Administrator 4.80
Onboard Administrator 4.80
HP VC Flex-10 Enet Module 
4.61
HP VC Flex-10 Enet Module 
4.61
HP VC 8Gb 24-Port FC Module 
3.08
HP VC 8Gb 24-Port FC Module 
3.08

Version of OneView: 4.10.01-0348545

Aaron Phillips
1 REPLY 1
Highlighted
Occasional Advisor

Re: OneView 4.1 not reporting correct Virtual Connect Firmware

Same problem. Two Enclosure c7000 added in monitoring mode. After updating the FW on the VC ( FlexFabric 10Gb/24), the firmware information is not updated in OneView. It was issue in versions OneView 4.20, 5.00 and 5.20. I can correct the issue only by re-adding Enclosure.