- Community Home
- >
- Software
- >
- HPE OneView
- >
- PXE Boot on Tunnel Network
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-03-2018 08:42 AM - edited 05-03-2018 09:00 AM
05-03-2018 08:42 AM - edited 05-03-2018 09:00 AM
PXE Boot on Tunnel Network
Hi,
we have an HPE infrastructure with HPE C7000+ VC 20/40 and Oneview, we are setting up a new infrastructure & process of configuring Autodeploy to boot stateless ESXi via PXE boot.
but the servers Profile are configured with Tunnel Network because the LIG is limited to 1000 VLANs and we have more than this limite.
My Question is the Tunnel Network support pxe boot ?
because I configured it, but the server didn't get an IP address from the DHCP.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-21-2018 05:50 PM
05-21-2018 05:50 PM
Re: PXE Boot on Tunnel Network
Yes, PXE can be supported with Tunnel Networks. Keep in mind that the upstream switch port's 802.1q Native VLAN value must match that of your deployment network. There is no way to specify the VLAN ID for your PXE network in the Connection, and depending on the Generation of platform, could be set in the BIOS settings.
I am an HPE employee