Unable to register this HP OneView instance with iLO

[UVA]

Dear All,

I am having issue in hp oneview 1.20 trial version of managed enclosure during the evaluation. i am having two servers in the enclosure but one of them is showing belwo issue. not sure what is stopping it as there is no commnucation issue.

The server, enclosure and the applicance all are in the same enclosure.

Unable to register this HP OneView instance with iLO: The iLO initialization was unable to complete..

Today 2:24:41 pm

Resolution

Restore access to the management processor and refresh the server hardware.

Your help or any hint much appriciated.

[johnhutch71]

Did you manage to respolve this problem as I'm now having the same problem with a single blade in my chassis.

John

[ChrisLynch]

What iLO firmware is loaded on your blades?  Can you reach the iLO Management UI from another system on the same subnet as the appliance (meaning, have you validated you don't have a Layer 2 or Layer 3 issue?)

[Cali]

And try to reset (reboot) the iLO.

I allways first Update the iLO Firmware and than add to OneView.

[UVA · Accepted solution]

Hi All,

seems the profile was created with BL460c Gen8 1 as my first server was Gen8 1. however when i added a second server i was unable to apply the profile template. later during r&d i discovered that the second server is BL460c Gen8 2 hardware. so i was unable to apply the profile. now i have created another profile template for BL460c Gen8 2 now it is working.

thanks.

[ChrisLynch]

Unless the iLO firmware is not at the Minimum Supported firmware as documented in the Support Matrix, and a valid Baseline (aka SPP Baseline) exists on the appliance, OneView will handle that for you if the iLO and/or the OA firwmare is not at the Managed Minimum Version (yes, this is a different version than the previously mentioned Minimum Supported firmware version is.)

[LeonLaude]

Hello,

I'm having the same issue in my company with several HP Bl460c Gen7 & Gen8 blades.

OneView version:  2.00.02-0219211

Blade Enclosure model: BladeSystem c7000 Enclosure G3

Blade Enclosure firmware version:
- OA: v. 4.40
- Interconnects: v. 4.41

OneView Baseline: HP Service Pack for ProLiant, 2015.10.0

All the HP BL460c blades have the newest iLO firmwares installed.

The The HP BL460c Gen8 blades have all the newest firmwares & drivers installed.

What I have tried:
- Restart the server.
- Removed /Re-added the server profile
- Removed / Re-inserted the server blade
- Changed iLO IP-address
- Tried Both DHCP & Static iLO IP-address
- Restarted OneView