P800 and Solaris

[somebody else]

I've installed solaris 10 8/07 onto a two drives connected to the P800 card (Raid 0+1) config and that has worked ok.

Now I want solaris to see all the other disks as JBODs so I have configured the other disks all in their own RAID0 (one disk one logical volume).

At boot the P800 reports all logical volumes are found, but solaris only shows the one logical disk which is the boot disk in a raid 0+1.

I've tried rebooting (several times)- upped the config for the card to support 32 drives but I still can not get the solaris box to see the other drives. I'm stuck and as far as I was aware this should have just worked - so obviously I'm missing something?

Anyone know what that missing bit is?

[Ivan Ferreira]

Have you tried with cfgadm, devfsadm, or touch /reconfigure and reboot?

[somebody else]

devfsadm did the trick. thanks!

[Ivan Ferreira · Accepted solution]

Glad it worked, please take your time to assign points to the answers you get. Please see:

http://forums1.itrc.hp.com/service/forums/helptips.do?#33

Have a nice day.

[somebody else]

see above for solution