HPE Community
HPE Storage Networking - Switches
1825775 Members
1889 Online
109687 Solutions
New Discussion

SN6500B No_Module Status change

 
necro82
Senior Member

‎04-03-2023 08:06 PM - last edited on ‎04-13-2023 11:59 PM by

‎04-03-2023 08:06 PM - last edited on ‎04-13-2023 11:59 PM by

SN6500B No_Module Status change

Hi.

SN6500B is in use. (Ver 8.2.2.d)

If you disable and enable an idle port (No_Ligth), it changes to the No_Module state.

Changing the SFP module is the same symptom.

Not only one port has this symptom, but several ports have this symptom.

Is it a hardware issue?

0 Kudos
Reply
1 REPLY 1
NimaG
HPE Pro

‎04-08-2023 02:45 AM

‎04-08-2023 02:45 AM

Re: SN6500B No_Module Status change

Hello necro82,

Theoretically, the port states mean:
No_Module - No module (GBIC or other) present.
No_Light - Module is not receiving light (valid for 8, 10, 16, and 32 Gb/s FC ports only).

Ideally, disabling / enabling the port will not change this port status.portDisableEnable.jpg

We'll need switch logs for a health check.
Kindly raise an HPE support ticket for further analysis on this switch.

Regards,



I work at HPE
HPE Support Center offers support for your HPE services and products when and how you need it. Get started with HPE Support Center today.
[Any personal opinions expressed are mine, and not official statements on behalf of Hewlett Packard Enterprise]
Accept or Kudo
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.