vSAN with HPE 5710

[Vinoth02]

Hi,

This is th efirst time am using HPE servers and switches for vSAN.
I have two sites with streached vSAN cluster, each site has four nodes. Am using  two HPE 5710 at each location for redunadancy. Can someone guide me the standard practice and what need to be configured within the HPE5710 switch.

In past with other swithese i followed these steps

interface port-channelXX
description XX-XX-XX
no shutdown
switchport mode trunk
switchport access vlan 1
mtu 9216

interface ethernet1/1/1
no shutdown
channel-group XX
no switchport
mtu 9216

vlt-domain 1
backup destination xx.xx.xx.xx
discovery-interface ethernet1/1/xx-1/1/xx
peer-routing
vlt-mac de:11:de:11:de:11

[support_s]

System recommended content:

1. HPE Synergy Installation and Recommended Practices Guide VMware vSAN ReadyNode on HPE Synergy for Gen10 and Gen9

2. HPE 5710-CMW710-R2612P08 Consolidated Release Notes

Please click on "Thumbs Up/Kudo" icon to give a "Kudo".

Thank you for being a HPE valuable community member.

[Parvez_Admin]

Hello @Vinoth02 , 

Thank you for reaching out to us! HPE Networking forum has moved to Aruba Airheads Community and for HPE Networking and Aruba product queries, request you to visit and post your query here: Aruba Airheads Community 

You can refer to the below link as well for more details:

HPE Networking forum migration to Aruba Airheads c... - Hewlett Packard Enterprise Community

[LuisFSalas]

Thank you so much for this info. I also visit this forum.

Can I find information about HP UX11.11?. At this moment I need many help on it.

My best regards,

Luis.

[Parvez_Admin]

@LuisFSalas ,

You may go to HPE Community HP-UX forums to post your query. Please find some of the board links below:

HP-UX-General

HP-UX-System Administration