Synergy 12000 Oneview setup through Cisco 3650 Stack

[MASUSN]

We originally setup the Synergy 12000 FLMs through an HP 5120A switch and all works fine. We no longer need the 5120 and would like to migrate the connections from there to cisco 3650 switch. There is nothing configured in the HP Switch ports.  We are using Fiber LC connections. Having troubles figuring out what needs to be programmed in the cisco switch for it to work.  Cannot get Oneview to show nor get the ports active. Do I need to reset the FLM's? Power cycle Composers and mainframe? What needs to be configured in cisco switch? Researched many things and cant quite find what I'm looking for.

[support_s]

System recommended content:

1. HPE Synergy 12000 Frame - Cabling

If the above information is helpful, then please click on "Thumbs Up/Kudo" icon.

Thank you for being a HPE community member.

[MASUSN]

Not helpful, already been down this route. I need to change from Hp switch to Cisco switch. 

[ChrisLynch]

You only need to validate the transceiver on the other end lights up and is Admin Up/Up. Do not configure an 802.1q trunk port, as the FLM DC port will only support access port config. There is nothing unique here.