HPE Community
HPE Synergy
1834626 Members
2743 Online
110069 Solutions
New Discussion

Re: Unable to open compute module consoles on two blades using OneView

 
Dave_Thacker
Contributor

‎10-06-2021 10:39 AM - last edited on ‎10-06-2021 08:53 PM by

‎10-06-2021 10:39 AM - last edited on ‎10-06-2021 08:53 PM by

Unable to open compute module consoles on two blades using OneView

After moving our one of our Synergy installation to a new network, we are unable to start console for two from OneView.   We see a message saying "Connected" and no further output.   We have physically reset both of the compute modules and that did not help.   We need to get into the console in order change the IP address of the iLO.   What can we do to poke the blades to open up the console?

Dave

"Leveraging Synergy across all technology platforms!"--Scott Adams
0 Kudos
Reply
1 REPLY 1
DanCernese
HPE Pro

‎10-06-2021 10:43 AM - edited ‎10-06-2021 10:45 AM

‎10-06-2021 10:43 AM - edited ‎10-06-2021 10:45 AM

Re: Unable to open compute module consoles on two blades using OneView

In Synergy, from OneView hardware there is an IPv4 address, IPv6 address, and DNS name with SSO.  You should be able to get there through one of those links without ever opening up a console.



I work at HPE
HPE Support Center offers support for your HPE services and products when and how you need it. Get started with HPE Support Center today.
[Any personal opinions expressed are mine, and not official statements on behalf of Hewlett Packard Enterprise]
Accept or Kudo
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.