Need help using Batch Operation to Set Trap Destination

[John H. Miller]

iMC ver 7.2 I need to set up a trap destination in several switches and Batch Mode seems to be the answer. However, I need the events to be ALL, but the batch operation sets it to NONE. Is there a way to change that or am I back to manually setting this up? OR...is there a way to create my own batch commands as there was in PCM?

Thanks - John Miller

[LindsayHill · Accepted solution]

Yes, you can easily push out your own set of commands. Check out the "Configuration and Change Management" section of the Admin Guide.

[John H. Miller]

Great! Found the procedure and it worked great! Thanks so much! - John