HPE Community
Insight Remote Support
1833750 Members
2371 Online
110063 Solutions
New Discussion

ISEE Client access

 
Erno Petro
Valued Contributor

‎08-24-2004 01:08 AM

‎08-24-2004 01:08 AM

ISEE Client access

Can I access an ISEE Client (at the customer, http://:5060/start.htm) from HP internal network via Spearhead portal?
HOW?
HPE SW Support
If you find that this or any post resolves your issue, please be sure to mark it as an accepted solution.
0 Kudos
Reply
3 REPLIES 3
Maurice Skubski_1
Valued Contributor

‎08-26-2004 07:34 PM

‎08-26-2004 07:34 PM

Re: ISEE Client access

depends. if the customer has an SPOP where you can connect via spearhed than you can open a Terminal Session via Spearhed on the SPOP and then open the clients gui. For this quesitions maybe it is better to use this internal forum: http://herkules.grc.hp.com/documents/software/isee/forum/board.php

regards ms
0 Kudos
Reply
Erno Petro
Valued Contributor

‎08-26-2004 09:42 PM

‎08-26-2004 09:42 PM

Re: ISEE Client access

Hi,

Thank you the answer, but I should like to access directly, not via SPOP rdp...
HPE SW Support
If you find that this or any post resolves your issue, please be sure to mark it as an accepted solution.
0 Kudos
Reply
Liem Nguyen
Honored Contributor

‎01-19-2005 05:15 AM

‎01-19-2005 05:15 AM

Re: ISEE Client access

No, you cannot access ISEE on a Client when you are at HP office. Spearhead allows you to access either SPOP or CAS, then you can launch IE (on the SPOP) and connect to ISEE Clients.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.