HPE Community
Integrity Servers
1849482 Members
5746 Online
104044 Solutions
New Discussion

RAID1 configure

 
SOLVED
Go to solution
SamirShrestha
Frequent Advisor

‎03-06-2011 11:05 PM

‎03-06-2011 11:05 PM

RAID1 configure

I've newly purchased HP RX3600 with built-in SAS3080X-HP sas controller card. I've connected two sas hard in slot 1&2. as per specification SAS3080X-HP support RAID level1 and I want to configure in same raid. How to configure raid1 ?
0 Kudos
3 REPLIES 3
Torsten.
Acclaimed Contributor

‎03-06-2011 11:37 PM

‎03-06-2011 11:37 PM

Re: RAID1 configure

You should get the guide

HP 8 Internal Port SAS Host Bus Adapter
(SAS Controller) Users Guide

from web (google it) - it has the detailed steps.

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Torsten.
Acclaimed Contributor

‎03-06-2011 11:47 PM

‎03-06-2011 11:47 PM

Solution

Re: RAID1 configure

http://h20000.www2.hp.com/bc/docs/support/SupportManual/c02017117/c02017117.pdf


page 32



Hard to find on BSC :-((

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
SamirShrestha
Frequent Advisor

‎03-09-2011 07:20 AM

‎03-09-2011 07:20 AM

Re: RAID1 configure

thanks
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.