rx2660 iLO 2 configuration backup

[ianvt]

I need to replace a rx2660 system board and so need to backup the iLO 2 MP configuration. Any suggestions?

[Torsten. · Accepted solution]

Note down the values (IP and users) and put them into the new MP.

No other possibility.

e.g.

MP:CM> ls

MP:CM> uc

[S_Logan]

Hi,

In Entry level servers we dont have a option!

In Supedomes we can sawpping the flash card will keep the settins!

[cnb]

Maybe use this utility?

"The HP Integrity Non-Volatile RAM Configuration Backup Utility provides the capability to archive and restore critical system settings and EFI Boot Manager options on hp Integrity servers."

ISO version:
http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareDescription.jsp?lang=en&cc=us&prodTypeId=15351&prodSeriesId=3346452&prodNameId=3346456&swEnvOID=54&swLang=13&mode=2&taskId=135&swItem=ux-71170-1

EFI version:
http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareDescription.jsp?lang=en&cc=us&prodTypeId=15351&prodSeriesId=3346452&prodNameId=3346456&swEnvOID=54&swLang=13&mode=2&taskId=135&swItem=ux-71168-1

HTH

Rgds,

[Torsten.]

That's not bad, it saves at least all the boot entries - sorry, forgot about this.

[cnb]

Yeah, it would have saved me about 2 hours of figuring out what the old paths and settings were supposed to be at.

Live and learn...

;-)

Rgds,

[ianvt]

Thanks for the reply's. I'm going to do the job on Monday. I have the NVRAM backup utility, was just wondering if there was an easy way of saving the iLO config. Clearly there is not.
Thanks
Ian