HPE Community
LAN Routing
1832994 Members
2089 Online
110048 Solutions
New Discussion

HP MSM430 Access point Trunk Port issue

 
nkempu20
New Member

‎05-02-2017 01:57 PM

‎05-02-2017 01:57 PM

HP MSM430 Access point Trunk Port issue

Hey Guys,

I am new to HP access point and i have some issues which i have not been able to figure out.

I have three VLANs on an Access point as follows

VLAN 15 . Production

VLAN 25 . Guest

VLAN 100. Management.

This access point is connected to a trunk port on a cisco 2960 switch. when i plug the access point to the trunk port, everything works normally but i cannot ping the management port (10.40.100.5) but when i connect it to an access port on the csico switch, i am able to ping the interface but then only VLAN 100 works. How can i have this access point connected to the trunk port and be able to ping the interface? Thanks

0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.