6.0.1.0 code problems

[JesseR]

Any having issues with this code on the 760s?

back on 7/25, I had a 760 controller that suddenly was really unresponsive.  Pinging either port was about 30% successfully at best... once logged into the web interface, the controller showed about 70% of the APs are Pending or Unresponsive.   The controller was sending massive amounts of errors out to our external Syslog server, and the guest VSC was no longer being broadcasted.    Rebooted the controller, everything was mostly fine... 

Except for the next 7 days or so, the APs were sending thousands of error messages per minute to my Syslog server, NONE of which actually affected AP operation it seemed...

Now today, the exact problem I had on 7/25 is back again and I had to reboot the controller, again.

Prior to 6.0.1.0 we ran 5.7.3.0 without any issues for months and months... 

I have a case opened with HP but, so far, nothing....

Jesse

[DougB-CCCP]

I'll throw out a "me too".

I have also seen this on an MSM710, it happens anywhere from a couple days to a couple weeks without notice.  I cannot log in to the controller (unresponsive) and have to power cycle it to get it running again.  After a power cycle, all is good for a while.  It happened on this controller with the 6.0.0 code as well.

I'm waiting for the next version of code to see if that helps at all.

[Dennis Handly]

>I'll throw out a "me too".

Then you might as well click on the "Me too" button on the initial post.

[DougB-CCCP]

Done. Didn't see the button. Thanks!