HPE Community
M and MSM Series
1833032 Members
2384 Online
110049 Solutions
New Discussion

Bridge with MSM422s

 
cky3
New Member

‎03-16-2011 05:21 PM - last edited on ‎12-01-2013 08:06 PM by

‎03-16-2011 05:21 PM - last edited on ‎12-01-2013 08:06 PM by

Bridge with MSM422s

Is is possibly to setup the MSM422s as a bridge? I currently have two setup as a local mesh, one in our main building (master) connecting to a slave in another building. All APs are controlled via a MSM760 controller and in their own VLAN. Connecting to wireless networks is working find ie. SSID egress mappings to VLANs are working correctly however wired devices are always geting addresses from the AP VLAN. I have an HP 2910al in the remote building where the remote AP connects. Wired devices are untagged in their VLAN. We do have some wired IP phone in which you can tag traffic directly on the phone which works just fine too. I am not sure what I am missing or if this is even possible.

 

 

P.S. This thread has been moved from Communications, Wireless (Legacy ITRC forum) to MSM Series. - Hp Forum MOderator

0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.