MSM422 AP

[Darren Etheridge_2]

We just purchased a new HP MSM422 AP. It is configured with a hard ip of 192.168.1.217. When we connect the AP to our network switch Procurve 3500yl (powered via POE) we get an IP conflict on 192.168.1.1 (even though it is hard ip'ed at 217). After the AP boots up completely the IP conflict goes away. Anyone have a way to fix this? Thanks!

P.S. This thread has been moved from Communications, Wireless (Legacy ITRC forum) to MSM Series. -HP Forum Moderator

[Shadow13]

I'm not sure about that but the AP uses the default ip address for it till it boots completely then it uses the configuration on it and the ip address defined there.

Regards