M and MSM Series
1832617 Members
3242 Online
110043 Solutions
New Discussion

MSM422 APs fails to connect to MSM760 controller

 
JesperF
Occasional Contributor

MSM422 APs fails to connect to MSM760 controller

Hi all,
 
I have a teamed setup with two MSM760 and a mix of MSM422 and MSM430 (123 APs in total).
 
My problem is that if I shut down the primary controller, only 2 of the MSM422 will connect. The remaining 35 MSM422 APs just says establishing tunnel, and then they disconnect after a while and then they try to connect again. I don't see this problem if I shut the secundary controller
 
I have recently upgraded firmware on the controllers to ver. 6.4.2.0-19648 hoping that it would solve the problem, but that didn't help.
 
 
Any good ideas

 

Rgds,

 

Jesper

2 REPLIES 2
Arimo
Respected Contributor

Re: MSM422 APs fails to connect to MSM760 controller

Are you doing L2 or L3 discovery? If L2, are you discovering on the Internet or LAN port subnet, or in a VLAN?


HTH,

Arimo
HPE Networking Engineer
JesperF
Occasional Contributor

Re: MSM422 APs fails to connect to MSM760 controller

it's layer3 discovery on the internet port.

 

This have worked before. It seems a bit strange that 2 MSM422 can connect to the controller, but 35 MSM422 can't

 

Kind regards,

 

Jesper