HPE Community
M and MSM Series
1754973 Members
3362 Online
108828 Solutions
New Discussion

MSM430 - set to autonomous mode then no access

 
pspecht
Occasional Contributor

‎09-04-2013 12:11 PM

‎09-04-2013 12:11 PM

MSM430 - set to autonomous mode then no access

I am setting up some MSM430 and choosing autonomous mode.  the web interface says it is restarting, and that is where it stays.  I cannot connect to the device after that.

 

The power button is green, and the LAN light flashes. 

 

I have the config guide and it says to go to 192.168.1.1 for the admin tool.  but no access.

0 Kudos
1 REPLY 1
pspecht
Occasional Contributor

‎09-04-2013 01:20 PM

‎09-04-2013 01:20 PM

Re: MSM430 - set to autonomous mode then no access

Okay.  found that the AP was using Ip of 192.168.0.X.  ?????

 

 

0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.