wireless mesh slave cycles

[furtlegog]

Hello all

I have a single master with 2 local mesh profiles 1 & 2 respectively. Slave 1 connected 2 mesh 1 and Slave 2 connected to mesh 2.

The problem is they all synch briefly then slave 1 starts to cycle, this causes slave 2 to drop off. Whilst slave 1 continually tries to rejoin slave 2 stays off. However you can still ping the device attached to slave 2. Everytime slave 1 tries to connect again the ping times to slave 2 increase.

If slave 1 is removed slave 2 sits there happily.

anyone have any ideas?

thanks in advance