MSA1050 Disk Groups Rebuild;

[Carlos_Oliveira]

Hi Team,

The product is HPE MSA1050.

I have a doubts About Disk Group priority rebuild process ...

Is there any configuration ( CLI ou GUI ) to set the Disk Group priority rebuild process, to increase or decrease the priority of the rebuild process ???

Best Regards,

Carlos Oliveira.

[Mahesh202]

Hi Carlos Oliveira

The only way to change the reconstruct/rebuild is to set the advanced settings - utility priority
This is set to HIGH by default
CLI>  show advanced-settings
CLI> set advanced-settings utility-priority
CLI Guide:  https://www.hpe.com/psnow/doc/a00017709en_us
In the WebUI:  System Topic -> Actions -> Advanced Settings -> System Utilities 

It's important to note that setting the rebuild priority to high can result in reduced system performance, as the rebuild process will take priority over other system tasks. Conversely, setting the priority to low may result in longer rebuild times but less impact on system performance.

It's recommended to carefully consider the impact of adjusting the rebuild priority and monitor the system performance during and after the rebuild process.

Hope this helps.!!

Regards
Mahesh

If you feel this was helpful please click the KUDOS! thumb below!