Beep code for Netserver LC 20000

[Philippe Scott]

I get a 1 3 3 1 beep code on my LC 2000 server, does anybody know what it means.

[Sanjay_6]

Hi,

If it is an AMI BIOS, it could be your display memory error. If the box has a plug in display controller, check whether the same is seated properly. Try the system in minimum conf mode.

http://us-support.external.hp.com/cki/bin/doc.pl/sid=ed9d0a6117cdf9a0be/screen=ckiDisplayDocument?docId=200000053490398

Hope this helps.

Thanks

[Marino Meloni_1 · Accepted solution]

hy

Beep Code Test Failure I/O port 80H Repair
1-3-1-1 Test DRAM refresh 20 S, P
1-3-1-3 Test 8742 Keyboard Controller 22 S, P
1-3-3-1 Test DRAM 28 M
1-3-4-1 Test 64K base address lines 2C M, P
1-3-4-3 Test 64K base memory 2E M, P
1-4-1-1 Test 64K base memory (upper 16 bits) 30 M, P
2-1-2-3 Copyright checksum 46 R

Beep Codes for Fatal Errors
P = Check and replace processor board
S = Check and replace system board
M = Check and replace memory modules
R = Replace ROM chip

as you can read the memory is probably defective or not well seated
bye
marino

[Philippe Scott]

I'll check