HPNetserver LHr4 D6973A

[william_161]

I have recently had a couple of these to test. I ran HP DiagTools Ver 2.40.2 on them. 2 passed but 1 failed with system board error. I ran advanced diags and the error was "PCI Bus transfer using Bus master cycles failed" with 008A error code. Would anyone be able to tell me if this is a serious fault or if its something I'm doing wrong?? Cheers

[Terri Harris · Accepted solution]

This is a known issue and is not any actual hardware problem. DiagTools will report a system board failure when in fact the system board is really ok. The specific PCI bus error you are reporting is most commonly seen in Netservers with the NetRAID-4M controller installed. It is not, however, a problem.