HPE Community
Netservers
1857319 Members
7704 Online
110372 Solutions
New Discussion

Re: Netserver TC 4100 NIC

 
Thomas Heyne
New Member

‎10-04-2003 02:18 AM

‎10-04-2003 02:18 AM

Netserver TC 4100 NIC

I have a problem with the integrated NIC. I' m only getting a 10 Mbit connection. My network infrastructure suports 100 Mbit. With a separate Intel pro 10/100 there are no problems with the network speed. The installed driver for the network-interface is the newest one from the hp website. If I switch the connection speed at from 10 Mbit/full duplex to 100 Mbit/half or full duplex, connection is lost. I get an error message that the network cable is disconnected.
0 Kudos
1 REPLY 1
Terri Harris
Honored Contributor

‎10-06-2003 06:06 AM

‎10-06-2003 06:06 AM

Re: Netserver TC 4100 NIC

What is the actual driver installed for the tc4100 integrated NIC?

What operating system are you running?

You may also want to run the HP diagnostics on this server & see if any problems are reported. DiagTools for the tc4100 is located here:

http://h20004.www2.hp.com/soar_rnotes/bsdmatrix/matrix78192en_US.html#Diagnostic
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.