- Community Home
- >
- Servers and Operating Systems
- >
- Legacy
- >
- Netservers
- >
- NIC Config
Netservers
1755702
Members
3079
Online
108837
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-19-2002 12:46 PM
03-19-2002 12:46 PM
NIC Config
Netserver 5/100 LC:
I Installed NE2000 network card in slot 1. When viewing system/board configuration, EISA lists as a PNP Netwrok Card. When I choose the appropriate cfg from ECU disk 2 I am then prompted to load floppy containing .cfg. Does that make sense?????
I Installed NE2000 network card in slot 1. When viewing system/board configuration, EISA lists as a PNP Netwrok Card. When I choose the appropriate cfg from ECU disk 2 I am then prompted to load floppy containing .cfg. Does that make sense?????
- Tags:
- NIC
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-19-2002 01:01 PM
03-19-2002 01:01 PM
Re: NIC Config
Yes.. With an EISA card you need to install the appropriate .cfg file which should have come with your NE2000 Eisa card. The floppy diskette with the .cfg file should have come your card.
Ciao,
Greg
Ciao,
Greg
Lets Roll!
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP