HPE Community
Netservers
1827458 Members
4730 Online
109965 Solutions
New Discussion

Problem on rebuilding RAID 1 on RS!2

 
Dante Zarate
Contributor

‎07-12-2001 11:29 PM

‎07-12-2001 11:29 PM

Problem on rebuilding RAID 1 on RS!2

Scenario:
LXR 8000 server with NT 4 as OS
with 2 RS-12 (each has 9 HDs)mirrored with each other (RAID 1)using NetRaid 3si as the controller

Problem:
One drive has failed from one of the RS-12

Action taken: replaced the failed drive with a new one then server was booted-up, it cannot recognise the replacement HD

Would NetRaid rebuild automatically a new inserted drive? Or do we have to back up first the NetRaid settings/config from the NVRAM in case rebuilding is not successful
The only thing to do with good advice is to pass it on. It is never of any use to oneself.
0 Kudos
1 REPLY 1
Mark Medici
Advisor

‎07-17-2001 06:57 AM

‎07-17-2001 06:57 AM

Re: Problem on rebuilding RAID 1 on RS!2

Automatic Rebuild can be enabled or disabled on the NetRAID-3si. You can use [Ctrl]+[M] when indicated during system startup to access the NetRAID Express Tools, and check/change this setting via [Objects]-->[Adapter].

You can use the NetRAID Assistant utility to check on the status of your drives and manually initiate a rebuild. You can also do the same via the NetRAID Express Tools.
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.