HPE Community
Netservers
1846087 Members
3961 Online
110253 Solutions
New Discussion

Re: Servers

 
SOLVED
Go to solution
GMAC
Occasional Contributor

‎10-01-2002 07:03 AM - last edited on ‎12-21-2012 01:17 AM by

‎10-01-2002 07:03 AM - last edited on ‎12-21-2012 01:17 AM by

Servers

What is the best way to uninstall software off a netware server.

 

 

P.S.This thread has been  from Servers>General to Servers > Netservers- HP Forums Moderator

0 Kudos
2 REPLIES 2
Robert_Jewell
Honored Contributor

‎10-02-2002 03:40 PM

‎10-02-2002 03:40 PM

Re: Servers

Reload. :)

Just joking. I really dont know much about NetWare, but I figured I would bump this to the top for you.

-Bob
----------------
Was this helpful? Like this post by giving me a thumbs up below!
0 Kudos
Jon Mattatall
Esteemed Contributor

‎10-03-2002 03:51 AM

‎10-03-2002 03:51 AM

Solution

Re: Servers

Whoooo...
It's been a few years, but as I recall the approved tools are INSTALL.NLM (in NW4) and NWCONFIG.NLM (in NW5). Just LOAD INSTALL or LOAD NWCONFIG the appropriate module, and you should be able to select "Product Options". From there you should get the option to remove a product. Select the software in question, and done.

Alternatively, you could just blow away directories, but that leaves a lot of gunk floating around that can confuse NDS. The NLMs are probably the way to go.

Jon (Dredging up my past)
A little knowledge is dangerous - none is absolutely terrifying!!!
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.