HPE Community
NonStop Servers
1832237 Members
2216 Online
110041 Solutions
New Discussion

How to Open a new port using SCF

 
nayrbbizkit
Occasional Contributor

‎07-24-2024 02:14 AM - last edited on ‎09-16-2024 02:31 AM by

‎07-24-2024 02:14 AM - last edited on ‎09-16-2024 02:31 AM by

How to Open a new port using SCF

Is there a way to Open a new port using SCF and assign to specific TCPIP process?

0 Kudos
Reply
1 REPLY 1
Mr_Techie
Trusted Contributor

‎07-31-2024 01:51 AM - last edited on ‎09-16-2024 02:30 AM by

‎07-31-2024 01:51 AM - last edited on ‎09-16-2024 02:30 AM by

Re: How to Open a new port using SCF

@nayrbbizkit

Firstly, you need to define the port in the TCP/IP process configuration.

Use SCF Commands to Configure the Port.

Assign the newly defined port to the specific TCP/IP process using the appropriate SCF command.

Once the configuration changes are made, you typically need to activate the configuration.

After configuration, verify that the port is open and correctly assigned by checking the status of the TCP/IP process or using network diagnostic tools.

 

I hope this helps! Let me know. 

0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.