HPE Community
Operating System - HP-UX
1825771 Members
2140 Online
109687 Solutions
New Discussion

Re: 11i v3 olrad add AD194. Network ports show unclaimed/unknown.

 
Robert Cook_6
Frequent Advisor

‎07-29-2010 10:37 AM

‎07-29-2010 10:37 AM

11i v3 olrad add AD194. Network ports show unclaimed/unknown.

I deleted an A9782 combo fc/sx card from a vpar via SMH. In it's place I added an AD194 combo fc/1000b-t card and the add finished successfully. The system sees the fc ports but not the network ports. There were no 1000b-t type cards in the system before. I checked the drivers
GE-DRV B.11.31.0903 HP PCI Gigabit Ethernet Driver
IETHER-DRV B.11.31.0909 HP PCI/PCI-X/PCIe Gigabit Ethernet Driver
IEXGBE-DRV B.11.31.0909 HP PCIe 10 Gigabit Ethernet Driver
IGELAN-DRV B.11.31.0909.01 HP PCI Gigabit Ethernet Driver
These drivers are the same as other systems that have the AD194 card installed. Rebooting the system didn't help. Any ideas?
Any sufficiently advanced technology is indistinguishable from magic. Arthor C Clark
0 Kudos
Reply
1 REPLY 1
Robert Cook_6
Frequent Advisor

‎07-29-2010 12:04 PM

‎07-29-2010 12:04 PM

Re: 11i v3 olrad add AD194. Network ports show unclaimed/unknown.

Discovered the "iether" module was "unloaded" in the kernel. I added it to the kernel and did a reboot. Now sees the network ports. All done from SMH, except the reboot.

Bob
Any sufficiently advanced technology is indistinguishable from magic. Arthor C Clark
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.