HPE Community
Operating System - HP-UX
1826190 Members
2358 Online
109691 Solutions
New Discussion

ACU-CLI for HPUX 11.31

 
Rick Cashion
New Member

‎02-19-2008 06:32 PM

‎02-19-2008 06:32 PM

ACU-CLI for HPUX 11.31

is there a manual on this? how do you start the acu?
0 Kudos
Reply
1 REPLY 1
Torsten.
Acclaimed Contributor

‎02-19-2008 11:46 PM

‎02-19-2008 11:46 PM

Re: ACU-CLI for HPUX 11.31

To get the software, you need to download the MSA1000 Support Software CD.

http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareDescription.jsp?lang=en&cc=us&prodTypeId=12169&prodSeriesId=377751&swItem=co-47057-1&prodNameId=305215&swEnvOID=7&swLang=8&taskId=135&mode=4&idx=0

In the HPACUCLI directory you will find the software depots and some readme files.

The path is /opt/compaq/hpacucli/bld , to start the cli run "hpacucli".


From the readme:


# hpacucli
HP Array Configuration Utility CLI 7.15.17.0
Detecting Controllers...Done.
Type "help" for a list of supported commands.
Type "exit" to close the console.

=>

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.