HPE Community
Operating System - HP-UX
1834724 Members
2448 Online
110069 Solutions
New Discussion

all sg command fail with permission denied prompt

 
Mohsen houshmand
Occasional Contributor

‎06-08-2007 03:48 AM

‎06-08-2007 03:48 AM

all sg command fail with permission denied prompt

dear all
befor start oracle clusterware (crs) all sg command run normally. but when crs is up all sg command will fail with following promt
Permission denied to 172.25.3.7
Permission denied to rp4440-1
0 Kudos
Reply
2 REPLIES 2
skt_skt
Honored Contributor

‎06-10-2007 10:29 AM

‎06-10-2007 10:29 AM

Re: all sg command fail with permission denied prompt

Check the syslog files of the current node and other cluster numbers and that should you give you some clue .

Why you are using both SG and crs together?
0 Kudos
Reply
skt_skt
Honored Contributor

‎06-10-2007 10:29 AM

‎06-10-2007 10:29 AM

Re: all sg command fail with permission denied prompt

Check the crs logs too.
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.