APA configure problem

[YAQUB_1]

Hi All,

I have trying to configure APA, but I canâ t properly. Could you please help me any one which configure level I have mistake. Iâ m not clear.

I have attached my system current configure.

Rgds--Yaqub.

[Ketan Kotak]

Hi Yaqub,

[1]
You have SAME IP address for lan1 and lan900:
INTERFACE_NAME[0]=lan1
IP_ADDRESS[0]=10.244.37.26
INTERFACE_NAME[1]=lan900
IP_ADDRESS[1]=10.244.37.26

[2]
You are better off using LAN_MONITOR mode Fail-Over Group instead of HOT_STANDBY mode.
To learn about LM, look for Chapter 5 in APA's Support Guide at: http://docs.hp.com/en/J4240-90035/J4240-90035.pdf

[3]
continue looking at your config...
Can you check if lan0 and lan2 are of SAME type? They should have same MTU, Speed, MAC Type, CKO settings etc..
Check both interfaces and see what is different among them?

Hope this helps.
Thanks and regards,
+ Ketan Kotak

[freddy_21]

Hello yaqub,
you can look at hp doc. www.docs.hp.com

for ketan kotak.
Hahaha.. Your id ketan kotak. very funny. your name really really original from indonesia hahahaa...


thanks
freddy