HPE Community
Operating System - HP-UX
1825721 Members
3134 Online
109687 Solutions
New Discussion

Asking for new output file when running fbackup

 
Jerry J. Moon
New Member

‎02-01-2006 10:57 AM

‎02-01-2006 10:57 AM

Asking for new output file when running fbackup

Just installed StorageWorks DLT VS160 on rp3410. Was able to (and still able to) run 'ignite-ux' with no problem but, when tried to run 'fbackup' the error msg appeared to provide new output file.

Tried with SAM with same result.

Currently running HP-UX 11.11 with most updated patches on the server.
Need help, please.
0 Kudos
3 REPLIES 3
James R. Ferguson
Acclaimed Contributor

‎02-01-2006 11:03 AM

‎02-01-2006 11:03 AM

Re: Asking for new output file when running fbackup

Hi Jerry:

You should have PHKL_33425 installed. Without it density may not be correctly set.

Regards!

...JRF...
0 Kudos
James R. Ferguson
Acclaimed Contributor

‎02-01-2006 11:10 AM

‎02-01-2006 11:10 AM

Re: Asking for new output file when running fbackup

Hi (again) Jerry:

Technical Knowledge Base document #lpg50167 also notes that for optimal performance you should increase the 'blocksperrecord' parameter from 16 to at least 32, and optimally to 64 in the 'fbackup' configuration file. See the manpages for 'fbackup' for more information.

Regards!

...JRF...
0 Kudos
Jerry J. Moon
New Member

‎02-01-2006 12:12 PM

‎02-01-2006 12:12 PM

Re: Asking for new output file when running fbackup

Thank you, James.

That did the job. I just wasn't sure whether that's all I had to do.

Thanks again and have a great day!
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.